Trek 11i, 9i RESTART- gETTINg REAdy TO RIdE



CLK

TME

AVG

MAX

TRP

ODO

Mode

Set

RESTART- gETTINg REAdy TO RIdE

Your computer stores data for two intervals- since last ReSet

and since last ReStart. ReSet sets ALL data to zero. ReStart sets

only the Trip data to zero.

The trip modes include

• TRP

• TME

• MAX

This operation sets all four values to zero, allowing the

computer to display information for a single ride.

1. Cycle Mode to TRP (Figure 16).

2. Hold Set•, and do not let up until after

completing step 3.

3. Hold Mode.

The Max setting ReStarts at ‘0’.

reStart

CLK TME AVG MAX TRP AVG

MPH

Figure 6- TrP screen

Contents

Main MPH CLK TME AVG MAX TRP AVG TREK INCITE 9i and 11i CONTENTS SAfETy ANd gENERAl guIdElINES function Explanation fuNCTIONS Page INSTAllATION Placing the computer on the handlebar To install the computer on handlebar To install the computer on the stem Placing the magnet To install the wheel magnet Attaching the computer wire To attach the computer wire Attaching the sensors To install the sensor Page EASy SETuP (RESET) using the buttons To set the units To set the odometer To set wheel size To select the wheel for use To set Clock RESTART- gETTINg REAdy TO RIdE To ReStart (set the Trip data to zero) AddITIONAl INfORMATION Changing mode Removing the computer from the computer base using the computer in wet weather TROuBlEShOOTINg REPlACINg ThE BATTERy To replace the battery Page SETTINg CuSTOM WhEEl SIzE Selecting the custom value 4-digit number To set the computer Page To measure rollout for wheel size lIMITEd WARRANTy This warranty covers This warranty does not cover