Introduction
Physical Details
Front-mounted LEDs
Broadband ADSL Router User Guide
Rear Panel
Power LED (Green)
Status LED (Yellow)
Figure 2: Front Panel
On - Power on.
Off - No power.
Off - Normal operation.
Blinking - This LED blinks during start up, and during a Firmware Up- grade.
| Figure 3: Rear Panel |
ADSL port | Connect this port to your ADSL line. |
10/100BaseT | Use standard LAN cables (RJ45 connectors) to connect your PCs to |
LAN connections | these ports. |
| Note: |
| Any LAN port on the Broadband ADSL Router will automatically |
| function as an "Uplink" port when required. Just connect any port to |
| a normal port on the other hub, using a standard LAN cable. |
Reset Button | This button will reset the Broadband ADSL Router to the factory |
(Reset to Defaults) | default settings. |
LAN | For each port, there are 2 LEDs, to indicate the connection speed |
| (10BaseT or 100BaseT) of each port. |
| • 100BT - This will be ON if the LAN connection is using 100BaseT, |
| and Blinking if data is being transferred via the corresponding LAN |
| port. |
| • 10BT - This will be ON if the LAN connection is using 10BaseT, and |
| Blinking if data is being transferred via the corresponding LAN port. |
| • If neither LED is on, there is no active connection on the correspond- |
| ing LAN port. |
ADSL | On - ADSL connection established. |
| Off - No ADSL connection currently exists. |
| Flashing - ADSL is synchronizing. |
Internet | On - Internet connection is available. |
| Off - No Internet connection available. |
| Flashing - Data is being transmitted or received via the ADSL connection. |
| To do this, press and hold the Reset Button for five (5) seconds, until |
| the Status LED is lit, then release the Reset Button, and wait the |
| Broadband ADSL Router to restart using the factory default values. |
Power port | Connect the supplied power adapter here. |
5 | 6 |
