Customize the Main and Controlled Outlet Groups
Use the Configuration menus to change the Main Outlet Group and the Controlled Outlet Group settings.
Function | Factory Default | Options | Description | |
|
|
|
| |
Name String | Outlet Group 1 | Edit these names using an external interface, such as the Network | ||
Outlet Group | ||||
| ||||
|
| Management Card Web interface. | ||
UPS Name String | UPS Outlets | |||
|
| |||
|
|
|
| |
Turn On Delay |
| Set the value in | The amount of time the UPS or a Controlled Outlet | |
0 sec | Group will wait between receiving the command to | |||
seconds | ||||
|
| turn on and the actual startup. | ||
|
|
| ||
|
|
|
| |
Turn Off Delay | • 0 sec UPS Outlets | Set the value in | The amount of time the UPS or a Controlled Outlet | |
• 90 sec Controlled | Group will wait between receiving the command to | |||
seconds | ||||
| Outlet Groups | turn off and the actual shut down. | ||
|
| |||
|
|
|
| |
Reboot Duration | 8 sec | Set the value in | The amount of time the UPS or a Controlled Outlet | |
seconds | Group must remain off before it will restart. | |||
|
| |||
|
|
|
| |
Minimum Return |
| Set the value in | The amount of battery runtime that must be available | |
0 sec | before the UPS or a Controlled Outlet Group will | |||
Time | seconds | |||
| turn on after a shutdown. | |||
|
|
| ||
|
|
|
| |
|
| • Enable | When the unit switches to battery power, the UPS | |
|
| • Disable | will disconnect power to the Controlled Outlet | |
Load Shed On |
|
| Group to save battery runtime. | |
Disabled |
|
| ||
Battery |
| Configure this delay time, use the LOAD SHED TIME | ||
|
| |||
|
|
| WHEN ON BATTERY setting. | |
|
|
|
| |
Load Shed Time | 1800 sec | Set the value in | The amount of time the outlets will function on | |
when On Battery | seconds | battery power before they will turn off. | ||
| ||||
|
|
|
| |
|
| • Enable | When the battery runtime falls below the specified | |
Load Shed On | Disabled | • Disable | value, the Controlled Outlet Group will turn off. | |
|
| |||
Runtime |
| Configure this time using the LOAD SHED RUNTIME | ||
|
| |||
|
|
| ||
|
|
| REMAINING setting. | |
|
|
|
| |
Load Shed On |
| Set the value in | When the remaining runtime reaches this level, the | |
Runtime | 120 sec | |||
seconds | Controlled Outlet Group will turn off. | |||
Remaining |
| |||
|
|
| ||
|
|
|
| |
|
| • Disabled | In the event of an overload (greater than 107% | |
Load Shed on | Disabled | • Enabled | output), the Controlled Outlet Group will | |
| immediately turn off to conserve power for critical | |||
Overload |
| |||
|
| loads. The Controlled Outlet Group will only turn on | ||
|
|
| ||
|
|
| again with a manual command. | |
|
|
|
| |
Network Management Card Settings
These settings are available only on units that have a Network Management Card (NMC) and are set at the factory. These settings can only be modified using an external interface, such as the NMC Web interface.
•NMC IP Address Mode
•NMC IP Address
•NMC Subnet Mask
•NMC Default Gateway
11 |
