Tricity Bendix BIW 102 installation instructions Electrical connections, Permanent connection

Models: BIW 102

1 32
Download 32 pages 35.55 Kb
Page 30
Image 30
Electrical connections

Electrical connections

Any electrical work required to install this appliance should be carried out by a qualified electrician.or competent person

WARNING: THIS APPLIANCE MUST BE WARNING: THIS APPLIANCE MUST BE  EARTHED. EARTHED.

The manufacturer declines any liability should this safety measure not be observed.

Before switching on, make sure the electricity supply voltage is the same as that indicated on the appliace rating plate (the plate is sticked to the rear of the appliance).

The appliance is supplied with a 13 amp plug fitted. In the event of having to change the fuse in the plug supplied, use a 13 Amp BS1362 fuse. Only ASTA or BSI approved fuses must be used.

Should the plug need to be replaced for any reason, proceed as described below.

The wires in the mains lead are coloured in accordance with the following code:

Green and Yellow

- Earth

Blue

- Neutral

Brown

- Live

Connect the green and yellow (earth) wire to the terminal in the plug which is marked with the letter «E»

or the earth symbol Ensure that the cut off plug is disposed of safely. or coloured green and yellow.

Connect the blue (neutral) wire to the terminal in the plug which is marked with the letter «N» or coloured black.

Connect the brown (live) wire to the terminal in the plug which is marked with the letter «L» or coloured red.

The plug must not be used if the fuse cover/carrier is lost. The cover/carrier is indicated by the coloured insert at the base of the plug.

A replacement cover/carrier must be obtained from your local Bendix Service Centre, whose address are listed in this instruction manual.

WARNING: a cut off plug inserted into a 13 Permanent connection amp socket is a serious safety (shock) hazard.

Ensure that the cut off plug is disposed of safely.

GREEN & YELLOW

E

A13

L

N

Manual background BROWN

BLUE

P1041

CORD CLAMP

 

Permanent connection

In the case of permanent connection it is necessary that you install a double pole switch between the appliance and the electricity supply (mains), with a minimum gap of 3 mm between the switch contacts and of a type suitable for the required load in compliance with the current electrical regulations.

The switch must not break the yellow and green earth cable at any point.

30

Page 30
Image 30
Tricity Bendix BIW 102 Electrical connections, Permanent connection, Warning This Appliance Must Be Earthed