INSTALLATION INSTRUCTIONS
THINGS YOU NEED TO KNOW
WARNINGS:
This cooker must be installed by a qualified electrician/competent person. Safety may be impaired if installation is not carried out in accordance with these instructions.
This cooker must be earthed.
Do not remove the screws from the earth tab extending from the oven mains terminal block (Fig. 8).
Before connecting the cooker make sure that the voltage of your electricity supply is the same as that indicated on the rating plate. The rating plate can be seen by opening the oven door and
llooking below the oven door seal.
Do not alter the electrical circuitry of this cooker.
NOTE: HOUSE CIRCUIT
Earth leakage and continuity tests must be carried out before the cooker is connected to the mains supply and
THINGS TO NOTE
This cooker is designed to be fitted in cabinets of the recommended dimensions as shown (Fig. 3 and 4) without any modification to the cabinet.
If your cabinet interior dimension is between
The dimensions given provide adequate air circulation around the unit within the cabinet, ensuring compliance with BS
Enquiries regarding the installation of the cooker point if required should be made to your Regional Electricity Company to ensure compliance with their regulations.
The cooker point should be within 2m of the cooker to make it accessible to switch off the
lcooker in case of an emergency.
To protect the hands wear gloves when lifting the oven into its housing.
GETTING THINGS READY
lCHOICE OF ELECTRICAL CONNECTION
There are two possible ways to connect your cooker, please choose from the most appropriate after reading the descriptions.
a)It is recommended that this appliance is wired with suitably rated cable (min 13A), into fixed wiring using a double pole isolator with at least 3mm contact separation in all poles and neutral, located within 2m of the appliance. If this fixed wiring circuit is only supplying the cooker, then a fuse of 13A (or circuit breaker) should be incorporated. When the circuit combines oven and hob, then wire and fuse rating should be increased accordingly.
Subject to Regional Electricity Company regulations if you wish to connect the oven and hob to the power supply you may use one of the following two methods:-
b)If you wish to connect an oven and a hob to a cooker point you can:-
i)By connecting the oven and hob separately to the cooker point. Oven and hob units should be separately connected to a control panel. In this case the cooker should be operated from 6mm² twin core, and earth, PVC insulated multicore cable. See Fig. 1.
Fig. 1
ii)By connecting the cooker point to the hob and then connecting to the oven. Provided that the hob manufacturer permits it, connect the oven to the hob and the hob to the cooker point using the same cabling as described in (a) above. Check the hob terminal block is large enough to take two cables and is of suitable rating. If not b) i) above must be used. See Fig. 2.
NOTE: 13 amp cable is not suitable for connecting this application.
8
