MAKING THE ELECTRICAL CONNECTIONS
Important: Switch off at mains, miniature circuit breaker and, if appropriate, remove fuse before commencing any electrical work.
PREPARING CABLE
We recommend you use a new length of cable to ensure your safety.
Ensure you have the correct length of cable appropriate to the wiring method you are using. When fitting new cable allow sufficient cable for removal of the unit at a later date, should it be necessary.
Score, but do not cut through, around the sheathing with a knife 100mm (4in) from each end of the cable and break through to the encased wires by bending the cable backwards and forwards to fatigue the sheathing.
Carefully score down from each end of the cable sheathing along the length of the bare earth wire (if a cut was made along the length of the live and neutral wires, it might cut into their sheathing) to the cuts
lalready made.
Carefully prise open the sheathing at each end of the cable to expose the encased wiring.
TO REMOVE COVER OF MAINS TERMINAL
From the rear of the cooker, remove mains input lterminal cover to gain access to terminal block.
First remove retaining screw with pozidrive screwdriver. See Fig. 5.
Pozidrive
Screwdriver
Fig. 5
lPrise cover loose using screwdriver in position
(1)then lever off with screwdriver in position (2) at either side. See Fig. 6.
(2)
Terminal(1)
Screwdriver
Fig. 6
lLift cover and remove screw from cable clamp. See Fig. 7.
Cable
Clamping
Block
Fig. 7
11
