Tricity Bendix BS680-1 Preparing Cabinet for Fitting of Oven, HOW to Finish Unpacking

Fig. 2

NOTE: It is good practice to:

Fit an Earth Leakage Circuit Breaker to your house wiring.

Wire your appliance to the latest IEE regulations.

PREPARING CABINET FOR FITTING OF OVEN

Make sure the cabinet is the correct size for the

lappliance to be fitted (Ref. Fig.3 and 4.)

If the size is between 565-570mm, then the cabinet should be modified so that at the screw fixing points the recommended dimension of at least 560-565mm is maintained. The modification should ideally be localised to ensure that after screw fitment the oven is securely fixed into

lposition.

The cabinet must be stable and level by firmly securing it to the wall or floor. If necessary, make arrangements to ensure the shelf upon which the oven will rest is level.

HOW TO FINISH UNPACKING

Place packed cooker next to the cabinet in which it will be installed.

Remove the cooker packing except for bottom tray which should be left in position until the

lcooker is ready to be fitted into its cabinet.

Ensure the owner is given these operating instructions.

TOOLS REQUIRED

The following tools will be needed and its helps to assemble them before starting to install your oven:-

A terminal screwdriver (3mm wide blade) A pozidrive screwdriver

Pliers

Wire strippers Knife Sidecutters Adhesive Tape Tape Measure

9