Trimble Outdoors AgGPS 252 Receiver

AgGPS 252 Receiver User Guide 55

Specifications A

A.3L-Band Satellite Differential Correction

Receiver

TableA.3 lists the characteristics of the L-band satellite differential

correction receiver with OmniSTAR support.

OmniSTAR HP position

accuracy

10cm (3 .94 in) after convergence, 2 sigma, if all the following

criteria are met:

•At least 5 satellites

•PDOP <4

•OmniSTAR HP corrections

Convergence time can vary, depending on the environment.

Time to the first fix (submeter accuracy) is typically <30seconds;

time to the first useable fix (<10 cm accuracy) is typically

<30minutes.

Time to first fix <30seconds, typical

Multipath mitigation EVEREST technology

Satellite differential

compatibility

OmniSTAR, WAAS, and EGNOS

NMEA messages GGA 1 11, GLL, GSA1, GST, GSV, GST, MSS, PTNLDG, PTNL PJK,

PTNL PJT, PTNL VGK, PTNL VHD, PTNLEV, PTNLID, PTNLSM,

RMC1, VGK, VTG1, XTE, ZDA

1 By default, the receiver is configured to output GCA, GSA, RMC, and VTG messages at a 1Hz

(1 position per second) update rate.

Table A.3 L-Band satellite differential correction receiver with

OmniSTAR support

Item Description

Bit error rate 10-5 for Eb/N of >5.5 dB

Acquisition and reacquisition time <5 seconds, typical

Frequency band 1525–1559MHz

Channel spacing 0.5kHz

Table A.2 GPS channels performance (continued)

Item Description

Ag252_100B_UserGuide_ENG.book Page 55 Thursday, July 28, 2005 4:06 PM

Contents

Main trimble_support@trimble.com www.trimble.com C Recycling in Europe Page Contents 1 Introduction . . . . . . . . . . . . . . . . . . . . . . .1 2 Overview . . . . . . . . . . . . . . . . . . . . . . . . .3 3 Installing the Receiver. . . . . . . . . . . . . . . . . 17 Page Introduction C Overview Page Page Page Page 2 Overview 8 AgGPS 252 Receiver User Guide Note WAAS/EGNOS and OmniSTAR VBS use the Satellite Differential GPS positioning method. Table 2.1 LED sequences with Satellite Differential GPS or Autonomous positioning Table 2.2 LED sequences with RTK positioning AgGPS 252 Receiver User Guide 9 Overview 2 Table 2.3 LED sequences with OmniSTAR HP positioning Table 2.2 LED sequences with RTK positioning (continued) Page Page Page AgGPS 252 Receiver User Guide 13 Overview 2 Table 2.5 Factors that influence the accuracy of GPS positions 2 Overview 14 AgGPS 252 Receiver User Guide Table 2.5 Factors that influence the accuracy of GPS positions (continued) Page Page Installing the Receiver Page C Page Page Page Page Page AgGPS 252 Receiver User Guide 25 Installing the Receiver 3 Table 3.4 Port B pinout Table 3.3 Port A pinout (continued) Page Configuring the Receiver D/3D 07 DOP03 WAAS 122 04 Page Page Operate in RTK Mode Page AgGPS 252 Receiver User Guide 33 Configuring the Receiver 4 The default port settings are: Table 4.1 Port input settings I RTCM 9600 8N1 0 NMEA 4800 Page Page Troubleshooting 38 AgGPS 252 Receiver User Guide Global Positioning System (GPS) AgGPS 252 Receiver User Guide 39 Troubleshooting 5 40 AgGPS 252 Receiver User Guide Page 42 AgGPS 252 Receiver User Guide Interference AgGPS 252 Receiver User Guide 43 Troubleshooting 5 GPS receiver AgRemote utility FlashLoader 200 upgrade utility Page Page AgGPS 252 Receiver User Guide 47 Ag252_100B_UserGuide_ENG.book Page 47 Thursday, July 28, 2005 4:06 PM START HERE Figure 6.1 Troubleshooting system hardware and power 48 AgGPS 252 Receiver User Guide Ag252_100B_UserGuide_ENG.book Page 48 Thursday, July 28, 2005 4:06 PM R E H AgGPS 252 Receiver User Guide 49 Ag252_100B_UserGuide_ENG.book Page 49 Thursday, July 28, 2005 4:06 PM R E H 50 AgGPS 252 Receiver User Guide Ag252_100B_UserGuide_ENG.book Page 50 Thursday, July 28, 2005 4:06 PM R E H AgGPS 252 Receiver User Guide 51 Ag252_100B_UserGuide_ENG.book Page 51 Thursday, July 28, 2005 4:06 PM START HERE Figure 6.5 Using AgRemote to troubleshoot RTK Page APPENDIX A AgGPS 252 Receiver User Guide 53 Specifications Tabl e A. 1 AgGPS 252 receiver A Specifications TableA.2 lists the performance characteristics of GPS channels. 54 AgGPS 252 Receiver User Guide Table A.2 GPS channels performance Tabl e A. 1 AgGPS 252 receiver (continued) AgGPS 252 Receiver User Guide 55 Receiver Table A.3 L-Band satellite differential correction receiver with OmniSTAR support Table A.2 GPS channels performance (continued) TableA.4 lists the receiver default settings. APPENDIX B AgGPS 252 Receiver User Guide 57 Third-Party Interface Requirements Table B.1 Third-party software interface requirements B Third-Party Interface Requirements TableB.2 lists the interface requirements for connecting an AgGPS receiver to third-party hardware. Table B.2 Third-party h ardware interface require ments Table B.1 Third-party software interface requirements (continued) AgGPS 252 Receiver User Guide 59 Third-Party Interface Requirements B Table B.2 Third-party hardware interface requirements (continued) B Third-Party Interface Requirements 60 AgGPS 252 Receiver User Guide Table B.2 Third-party hardware interface requirements (continued) Index Numerics A B C D E F G H I J L M P R S T U V W Y