1111 W. 35th Street
Chicago, IL 60609 USA
Customer Support: (773)
www.tripplite.com
A B C D
Mounting Instructions
Wallmount
Bracket
for the SmartPro® 1400XL NET,
BP-36V27 and SNMP Solo
ESPAÑOL: p. 2 FRANÇAIS: p. 2
E
Mounting the Bracket on a Wall
Hold the Bracket level against the intended mount- ing surface and mark the locations of the mounting holes (A). Drill 1/8” guide holes in these locations. Place the included wash- ers around the included screws, then drive the screws through the mount- ing holes and into the guide holes.
CAUTION: The hardware (screws and washers) in- cluded with the Bracket is only intended for use with plywood surfaces. To mount your Bracket on a different surface, you must determine a safe mounting procedure and obtain proper hardware.
Mounting a SmartPro or Battery Pack
CAUTION: Before mounting a SmartPro UPS, make sure the UPS is OFF and un- plugged. Before mounting a
Place the UPS or battery pack in the mounting tray. The feet of a UPS should press against the rear ridge
(B)and fit around the center ridge (C) while the front of the UPS presses against the front ridge (D). The base of a battery pack should fit between the rear (B) and center (C) ridges, with its cords facing the wall.
Next, Pass the safety strap around the UPS or battery pack and through the mounting tray as shown. The safety strap should pass through the tray’s outer strap holes for a UPS or through the tray’s inner strap holes for a battery pack. Fully tighten the safety strap and fasten the velcro end.
Mounting a SNMP Solo
Affix one of the
Copyright © 2000 Tripp Lite. All rights reserved. SmartPro® is a registered trademark of Tripp Lite.
