Tripp Lite 2200XLT Installation, Plug your UPS into an electrical outlet, Plug your equipment

Installation

1 Plug your UPS into an electrical outlet.

The SmartPro 2200XLT should be connected to a 15-amp dedicated circuit.

2	Plug your equipment
	into your UPS.

Your UPS is designed to support only computer equipment. Connecting household appliances, laser printers or surge suppressors is not recommended.

3	Turn your UPS ON.
	Set the System Enable Switch (DIP
	· Switch #4, UPS back panel) to the

“ENABLE” (UP) position.

(See Figure 1)

This switch activates the battery charger and microprocessor.

The “” light will flash until you engage the ON/Standby Switch to activate the “ON” mode.

·Engage the momentary ON/Standby Switch (UPS front panel) and release it to activate the “ON” mode and supply power to the UPS receptacles.

(See Figure 2)

Figure 1		DIP Switch #4
		(System Enable Switch)
	ENABLE
	DISABLE

Figure 2 - ON/Standby Switch

DB9 Port Connection (Optional) On Next Page . . .

3