Invacare 1080556 manual INSTALLING/REMOVING Rear Wheels, Wheels/Forks, QUICK-RELEASE Figure

WHEELS/FORKS PROCEDURE 8

This Procedure Includes the Following:

Installing/Removing Rear Wheels

Adjusting the Quick-Release Axle

Seat-to-Floor Height Adjustment

Adjusting Forks

WARNING

After ANY adjustments, repair or service and BEFORE use, make sure all attach- ing hardware is tightened securely - otherwise injury or damage may result.

INSTALLING/REMOVING REAR WHEELS

QUICK-RELEASE (FIGURE 1)

NOTE: To remove rear wheels, reverse this procedure.

1.Push in the detent pin of the quick-release axle and insert the quick-release axle through the center of the rear wheel.

2.Push in the tip of the quick-release axle again and insert the axle (with wheel) into the axle mounting plate on the side of the wheelchair frame until the assembly locks in place.

WARNING

Make sure detent pin and locking pins of the quick-release axles are fully released BEFORE operating the wheelchair.

The locking pins MUST be protruding past the inside of the axle mounting plate for a positive lock.

Keep locking pins clean.

3.	If the locking pins of the quick-release	Wheelchair
	axles are not protruding past the inside of
	the axle mounting plate or there is too	Frame
	much movement of the rear wheel	Axle Mounting
	assembly in a back and forth position,
	refer to ADJUSTING THE QUICK-	Plate
	RELEASE AXLE in this procedure of the	Locking
	manual.
		Pins
4. Repeat STEPS 1-3 for other rear wheel
		Detent
	assembly.
		Pin
5.	Adjust the wheel locks. Refer to WHEEL
	LOCK ADJUSTMENT in PROCEDURE 9 of
	this manual.
NOTE: Only 12-inch rear wheel is shown. All other		Quick-Release
		Axle
wheels will install/remove in the same manner.		Rear Wheel

FIGURE 1 - INSTALLING/

REMOVING REAR WHEELS -

QUICK-RELEASE

WHEELS/FORKS

Part No. 1080556 Rev. I 49 Solara™