FRONT RIGGINGS | PROCEDURE 4 | |
| COMPOSITE/ARTICULATING FOOTPLATE HEEL LOOP | |
| REPLACEMENT (FIGURE 5) | COMPOSITE FOOTPLATE |
DISASSEMBLY
Composite.
1.Remove the hex screw and coved spacer that secure the lower footrest assembly to the swing away footrest assembly.
2.Remove the lower footrest assembly.
3.Remove the phillips screw and locknut that secure the heel loop to the footrest.
4.Slide heel loop off of the footrest.
Articulating.
1.Remove the phillips screws, washers and spacers that secure the heel loop to the articulating footplate.
REASSEMBLY
1. Replace heel loop.
Swingaway Footrest Assembly
Hex Screw and Coved Spacer
Phillips Screw |
|
| |
| Lower Footrest | Phillips | |
| Screws | ||
Spacer | Assembly | ||
| |||
|
| ||
Heel |
| Washer | |
|
| ||
Loop |
| Heel | |
|
| ||
Locknut | Spacer | Loop | |
|
|
ARTICULATING
FOOTPLATE
FRONT RIGGINGS
2. Reverse the disassembly procedures. | FIGURE 5 - COMPOSITE/ |
NOTE: When securing the heel loop to the footrest as- | ARTICULATING FOOTPLATE |
sembly, tighten phillips screw until the spacer is secure. | HEEL LOOP REPLACEMENT |
INSTALLING/REMOVING ELEVATING LEGREST/CALFPAD ASSEMBLY (FIGURE 6)
INSTALLING
1.Insert the footplate assembly into the calfpad assembly and secure it with bolt and nut.
2.Place legrest/calfpad assembly on the outside of the wheelchair and insert legrest mounting pin into the legrest mounting tube on the wheelchair frame.
3.Rotate legrest/calfpad assembly toward the inside of the wheelchair until it locks in place.
NOTE: The calfpad of the legrest will be on the inside of the wheelchair when locked in place.
4.Repeat STEPS
Legrest | Legrest Mounting Pin |
Mounting |
|
Tube | Calfpad |
| |
| Assembly |
Bolt and
ReleaseNut
Wheelchair Handle
Frame
Footplate Assembly
FIGURE 6 - INSTALLING/
REMOVING ELEVATING LEGREST/
CALFPAD ASSEMBLY
5.Adjust the footplate to the correct height by loosening the bolt and nut and sliding the inner tube up or down until desired height is achieved. Securely tighten bolt and nut.
REMOVING
1.Push the legrest release handle inward while rotating the footrest outward.
2.Lift the legrest assembly out of the legrest mounting tube.
Part No. 1080556 Rev. I | 25 | Solara™ |
