ARMS

PROCEDURE 5

This Procedure Includes the Following:

Installing/Removing/Adjusting Dual Point Armrest

Using/Installing/Adjusting Locking Cantilever Arms

Using/Installing/Adjusting Non-Locking Cantilever Arms

Arm Pad Replacement for Cantilever Arms

Installing/Removing T-Arms

Adjusting the T-Arms

Adjusting Transfer Assists and/or Side Guards - Arms

WARNING

After ANY adjustments, repair or service and BEFORE use, make sure all attach- ing hardware is tightened securely - otherwise injury or damage may occur.

INSTALLING/REMOVING/ADJUSTING DUAL POINT ARMREST (FIXED AND ADJUSTABLE HEIGHT) (FIGURE 1)

WARNING

Make sure the locking mechanism is secured BEFORE using the wheelchair.

INSTALLING ARMREST

1.Unlock armrest assembly by flipping the arm assembly release lever located on the side rail to the UP (HORIZONTAL) position as shown in DETAIL "A" .

NOTE: Armrest locks MUST be in the unlocked position when placing arm into the arm sockets.

2.Install armrest assembly into the arm sockets.

3.When installed, lock the armrest assembly by pressing the release lever into the DOWN (VERTICAL) position as shown in DETAIL "A".

4.Repeat STEPS 1-3 for the opposite side of the wheelchair.

5.If necessary, adjust the armrest height. Refer to ADJUSTING ARMREST in this procedure of the manual.

REMOVING ARMREST

1.Unlock armrest assembly by flipping the arm assembly release lever located on the side rail to the UP (HORIZONTAL) position as shown in DETAIL "A".

2.Pull up on the armrest assembly to remove the armrest from the arm socket.

3.Repeat STEPS 1-2 for opposite side of wheelchair, if necessary.

ARMS

Part No. 1080556 Rev. I

27

Solara™

Page 27
Image 27
Invacare 1080556 manual Arms Procedure, Installing Armrest, Removing Armrest