PROCEDURE 5

ARMS

Back Cane

ARMS

Adjustment Plate

Coved Washers

Actuator

Spacer

Top Hex Bolt

and Coved Washer

Cantilever Arm

Bottom Hex Bolt

Locknuts

Washers

FIGURE 3 - INSTALLING LOCKING CANTILEVER ARMS /

ADJUSTING LOCKING CANTILEVER ARM HEIGHT

ADJUSTING LOCKING CANTILEVER ARM ANGLE (FIGURE 4)

NOTE: This adjustment is recommended if the back angle has been changed.

1.Flip the cantilever arm up and out of the way.

2.Remove the locknut that secures the locking pin to the arm adjustment plate.

3.Refer to FIGURE 4 to determine the mounting hole in the arm adjustment plate that will be used to correspond to the back angle.

4.Securely tighten the locking pin and washer to the adjustment plate with a locknut.

5.Repeat STEPS 1-4 for the opposite side, if necessary.

Solara™

30

Part No. 1080556 Rev. I

Page 30
Image 30
Invacare 1080556 manual Adjusting Locking Cantilever ARM Angle Figure, Procedure Arms