RECLINER BACK OPTION

PROCEDURE 10

 

 

 

WARNING

DO NOT over tighten the adjusting nut on the recliner cable. Overtightening the adjusting nut on the recliner cable WILL actuate the gas cylinder, possibly causing injury.

A.CLOCKWISE - Turning the cable adjusting nut clockwise will tighten the recliner cable. DO NOT overtighten the cable adjusting nut. Turn the cable adjusting nut clockwise until actuator looks like DETAIL "B".

B.COUNTERCLOCKWISE - Turning the cable adjusting nut counterclockwise will loosen the recliner cable.

NOTE: If the recliner cable is too loose, the gas cylinders will not work.

C.While holding the cable adjusting nut in place, tighten the cable locking nut against the cable adjusting nut.

D.Repeat STEP 1.

E.Repeat STEP 2 until the LEFT side of the back DOES NOT recline.

3.Squeeze the trigger release lever of the RIGHT recliner cable assembly and try to recline the back. The back should not recline.

4.To adjust the RIGHT gas cylinder:

Repeat STEPS 1-3 for the LEFT handle of the recliner cable.

RECLINER BACK OPTION

Trigger

Release

Lever

Cable Locking

Nut

Cable Adjusting

Nut

DETAIL "B"

MUST TOO TOO

LOOK LOW HIGH LIKE THIS

Actuator Actuator

Housing

FIGURE 5 - PERFORMING ADJUSTMENTS

Part No. 1080556 Rev. I

63

Solara™

Page 63
Image 63
Invacare 1080556 manual Detail B Must TOO TOO Look LOW High Like this