RECLINER BACK OPTION

PROCEDURE 10

 

 

 

7.Squeeze the trigger release lever that controls the EXISTING gas cylinder (the gas cylinder that has NOT been removed).

8.While squeezing the trigger, raise OR lower the recliner back until the mounting holes of the NEW gas cylinder align with the mounting holes in the bracket of the back cane.

9.Reinstall the EXISTING button head cap screw through the EXISTING recliner brackets, spacer, gas cylinder, nylon washer, mounting bracket and washer and tighten securely with the EXISTING locknut.

10.If necessary, repeat STEPS 1-9 for the opposite gas cylinder.

11.Adjust the NEW gas cylinder(s). Refer to ADJUSTING THE GAS CYLINDERS in this section of the manual.

Actuator Housing

Squeeze Trigger Release

Lever To Align Mounting

Holes (STEP 7, 8)

Jam Nut

(STEPS 1, 4,6)

Cylinder Rod

 

Gas Cylinder

 

Button Head Cap Screw

 

(STEPS 2, 9)

Locknut (STEPS 2, 9)

 

Bracket

Washer (STEPS 2, 9)

 

Spacer (STEPS 2, 9)

Nylon Washer (STEPS 2, 9)

 

FIGURE 4 - REPLACING THE GAS CYLINDERS

RECLINER BACK OPTION

Part No. 1080556 Rev. I

61

Solara™

Page 61
Image 61
Invacare 1080556 manual Replacing the GAS Cylinders