BACK/SEAT

PROCEDURE 6

BACK/SEAT

INSTALLING/REMOVING/ADJUSTING THE ADJUSTABLE ANGLE STROLLER HANDLES

NOTE: Adjustable angle stroller handles are bolted onto recliners ONLY.

INSTALLING (FIGURE 3)

1.Remove plug buttons from both back canes.

2.Slide the adjustable height stroller handle into the back canes.

3.Align the mounting holes of the adjustable angle stroller handle and the back cane.

4.Secure adjustable angle stroller handle to the back canes with the two (2) quick-release pins or the two (2) bolts and locknuts.

5.If necessary, adjust the height. Refer to ADJUSTING in this procedure of the manual.

REMOVING (FIGURE 3)

1.Press and hold the buttons on the quick-release pins

2.Remove the adjustable angle stroller handle from the back cane.

3. Install plug buttons.

NOTE: Plug buttons not shown for clarity.

Quick-Release Pin

(or bolt and locknut -

Recliners ONLY)

DETAIL "A" -

QUICK-RELEASE PIN INSTALLED

Back Cane

Detent

Ball

Stroller Handle

Back Cane

NOTE: Bolts and locknuts not shown. Bolts and locknuts install in same location as quick-release pins.

Quick-Release Pin (or bolt and locknut - Recliners ONLY)

FIGURE 3 - INSTALLING/REMOVING THE ADJUSTABLE ANGLE

STROLLER HANDLES

Solara™

40

Part No. 1080556 Rev. I

Page 40
Image 40
Invacare 1080556 manual Installing Figure, Removing Figure, Detail a QUICK-RELEASE PIN Installed