Invacare 1080556 manual Adjusting the QUICK-RELEASE Axle Figure, Permanent Axle

WHEELS/FORKS

PROCEDURE 8 WHEELS/FORKS

PERMANENT AXLE (FIGURE 2)

NOTE: To remove rear wheels, reverse this procedure.

1.	Remove the permanent axles from the
	packaged container.
2.	Install permanent axle through the rear
	wheel and axle plate.
3.	Securely tighten the wheel to the
	wheelchair frame with locknut.	Axle Plate
NOTE: Only 12-inch rear wheel is shown. All other			Permanent
		Rear Wheel	Axle
wheels will install/remove in the same manner.
		FIGURE 2 - INSTALLING/
4.	Repeat STEPS 2-3 for other rear wheel
		REMOVING REAR WHEELS -

assembly. PERMANENT AXLE

5.Adjust the wheel locks. Refer to WHEEL LOCK ADJUSTMENT in PROCEDURE 9 of this manual.

ADJUSTING THE QUICK-RELEASE AXLE (FIGURE 3)

1. Remove rear wheel and quick-release	Rear Wheel
axle from the wheelchair. Refer to
INSTALLING/REMOVING REAR	(Reference)
WHEELS in this procedure of the	Axle Mounting
manual.
	Plate

2.Depress detent pin in the quick-release axle and slide axle through the wheel hub.

3.	Increase or decrease end play in the quick	Locking Pins	Locknut
	release axle by adjusting the locknut on		Detent
	the end of the quick-release axle.
			Pin
4.	Reinstall rear wheel onto the wheelchair.
	Refer to INSTALLING/REMOVING REAR	Wheel Hub	Quick-
	WHEELS in this procedure of the manual.
5.	Release detent pin ensuring that the	(Reference)	Release
			Axle
	locking pins are fully released.
6.	Repeat STEPS 3-5 until the quick-release	FIGURE 3 - ADJUSTING THE
	axle locks properly.	QUICK-RELEASE AXLE

7. Repeat STEPS 1-6 for opposite side, if necessary.

Solara™ 50 Part No. 1080556 Rev. I