Invacare 1080556 manual Angle Adjustment of the Contracture

CONTRACTURE FOOTPLATE OPTION

PROCEDURE 11 CONTRACTURE FOOTPLATE OPTION

ANGLE ADJUSTMENT OF THE CONTRACTURE
FOOTPLATE (FIGURE 6)		Flat Screws
1. Loosen, but DO NOT, remove the two	Contracture
	Assembly
(2) flat screws, washers and locknuts that
		Contracture
secure contracture footplate to the
		Footplate
footplate hinge.
2. Tilt the contracture footplate UP/	Footplate
DOWN to achieve desired angle.	Hinge
3. Retighten the two (2) flat screws,	NOTE: Mounting
washers and locknuts that secures		Washers
	hardware removed
the contracture foot plate to the
	for clarity only.	Lock Nuts
footplate hinge.
4. If necessary, repeat STEPS 1-3 on	NOTE: Bilateral contracture footplate shown
remaining contracture footplate.	for clarity.
	FIGURE 6 - ANGLE ADJUSTMENT
	OF THE CONTRACTURE
	FOOTPLATE
CONTRACTURE FOOTPLATE DEPTH ADJUSTMENT
(FIGURE 7)	BILATERAL CONTRACTURE
NOTE: Observe the angle of the contracture		Flat Screws
footplate for reinstallation.
1. Perform one (1) of the following:		Mounting Hole

A.BILATERAL CONTRACTURE -

Remove the two (2) flat screws,
washers and locknuts that secure the	Contracture
contracture footplate to the footplate
	Footplate
hinge.
B. CONTRACTURE PLATFORM -		Washers
Remove the four (4) flat screws that	Footplate Hinge	Lock Nuts
secure the contracture platform to
	CONTRACTURE PLATFORM
the half clamps.

2. Move the contracture footplate to one (1)
of four (4) mounting hole.	Flat Screws

3. Perform one (1) of the following:

A.BILATERAL CONTRACTURE - Reinstall the two (2) flat screws, washers and locknuts that secure the contracture footplate to the footplate hinge.

B.CONTRACTURE PLATFORM - Reinstall the four (4) flat screws that secure the contracture platform to the half clamps. Tighten securely.

Contracture

Platform

FIGURE 7 - CONTRACTURE

FOOTPLATE DEPTH

ADJUSTMENT

Solara™ 68 Part No. 1080556 Rev. I