FRONT RIGGINGS | PROCEDURE 4 |
ADJUSTING SWINGAWAY FOOTREST HEIGHT
HEIGHT ADJUSTMENT RANGES:
60° | |
70° | |
90° | |
90° |
|
NOTE: If using ANY type of extension with the ADJUSTABLE
ADJUSTABLE ANGLE
Hex Screw
Coved
Spacer
Footrest Upper
Support
Mounting
Tube
FRONT RIGGINGS
60°, 70° and 70° Taper (FIGURE 2)
1. Remove the footrest from the wheelchair. Refer to INSTALLING/REMOVING
SWINGAWAY FOOTREST in this procedure of the manual.
2. Remove the hex screw and coved spacer and slide the footrest up or down on its mounting tube until the desired footrest height is achieved.
3. Reassemble the hex screw and coved spacer through the footrest upper support and mounting tube as shown in FIGURE 2.
4. Securely tighten the hex screw and coved spacer.
5. Install the footrest assembly onto the wheelchair. Refer to INSTALLING/REMOVING SWINGAWAY FOOTREST in this procedure of the manual.
6. Repeat STEPS
70° MFX AND 90° FOOTRESTS (FIGURE 3)
1.Remove any accessories that are attached to the footrests.
2.Remove the socket bolt, coved washer and locknut that secure the footplate to the footrest support.
3.Reposition the footplate to the desired height.
4.Reinstall the socket bolt through the mounting holes of the footplate and footrest support.
WARNING
DO NOT overtighten socket bolt and locknut. Footrest MUST be able to rotate upward from the horizon- tal to the vertical position.
Footrest Support
Height
Adjustment
Holes
Locknut | Socket Bolt |
Footplate
FIGURE 3 - INSTALLING/REMOVING/
ADJUSTING THE FOOTREST(S) - 70° MFX AND 90° FOOTRESTS
5.Secure the footplate to the footrest support with the coved washer and locknut.
Part No. 1080556 Rev. I | 23 | Solara™ |
