TRANSPORT READY OPTION | PROCEDURE 12 |
SECUREMENT POINTS (FIGURE 1) |
|
FRONT | REAR |
|
| ||
| Bracket |
| |
Brackets | |||
| |||
| Bracket | ||
|
|
FIGURE 1 - SECUREMENT POINTS
SECURING THE WHEELCHAIR
WARNING
Ensure
This wheelchair is to be used only with Wheelchair
Systems (WTORS) that have been installed in accordance with the manufacturer's instruc- tions and SAE J2249.
NOTE: A copy of SAE J2249 Wheelchair
Motor Vehicles can be obtained from: SAE International, 400 Commonwealth Drive, Warrendale, PA
Attach WTORS to the
SECURING THE OCCUPANT
WHEELCHAIR-ANCHORED BELTS (FIGURE 2)
WARNING
The pelvic belt that is provided by Invacare has been tested for use in a motor vehicle on this wheelchair ONLY. DO NOT replace the pelvic belt with a different style pelvic belt.
The wheelchair has been provided with a pelvic belt which meets the requirements of ANSI/ RESNA WC/19.
The pelvic belt provided by Invacare has been designed to accommodate use on either side of the vehicle. If necessary, follow the instructions below to reverse the orientation of the pelvic belt to accommodate the
1. Install the pelvic belt pin (DETAIL "A" of FIGURE 2) into slot in the pelvic belt bracket.
NOTE: Note the position of the male end of the belt when installing the pelvic belt onto the pelvic belt brackets. The male end of the pelvic belt (DETAIL "A" of FIGURE 2) has a pin which is used to secure the
2.Repeat STEP 1 for the opposite pelvic belt bracket.
3.Install the
TRANSPORT READY OPTION
Part No. 1080556 Rev. I | 73 | Solara™ |
