Sharp electonic cash register Data loading, Error message table of the SD card function

■■ Data loading

The programming data can be loaded from the SD card.

Procedure

(1)Select “2 LOADING” in the SD CARD mode and press the Akey. The following selection window is displayed.

Item	Data list
	Select the individual programming data:
	DEPARTMENT
	PLU
IND. PROGRAM	CLERK
	GRAPHIC LOGO
	LOGO TEXT
	TAX
ALL PROGRAM	All programming data
ALL RAM DATA*	All RAM data

(2)Select the data menu from the list and press the Akey, the confirmation window is displayed. To load the programming data file, select OK and press the Akey.

To cancel the operation, select CANCEL and press the Akey.

*When “ALL RAM DATA” is selected, the register resets the program in the last save point after loading all the RAM data.

NOTE The loading operation must be circumspect in execution, the sales data and/or all programming data will be recovered with the back-up data.

Error message table of the SD card function

Error message (display)	Error status and action
	The SD memory card is full. Delete unnecessary data from the card on a PC or
CARD FULL	replace the card with a new one. When using a new SD memory card, be sure
	to format it in advance.
CARD PROTECT	The write-protect switch on the SD memory card is in the “PROTECTED”
	position. Set the switch on the “NOT PROTECTED” position.
FILE FAILED	The data stored in the SD memory card is incorrect. Write correct data into the
	SD memory card on a PC.
NO CARD	No SD memory card is found. Insert an SD memory card into the SD card slot
	or reinsert it correctly.
NO FILE	The designated file is not found.
NO FOLDER	The user folder is not found. (SHARP/ECRER2X7/user folder name)
	The maximum allowable number of times of sales data writing is exceeded.
OVER LIMIT.	Delete unnecessary data from the SD memory card on a PC or replace the
	card with a new one. When using a new SD memory card, be sure to format it
	in advance.
SD ACC POWER OFF	A power failure has occurred while the SD memory card is accessed. Perform
	the interrupted operation again from the beginning after power recovery.
SD ERROR	An error other than the above mentioned has occurred while the SD memory
	card is accessed. Perform the interrupted operation again from the beginning.

95