Tripp Lite B070-008-19-IP Console KVM Switch Rear View, Rackmount KVM Switch Front View

1.. Product Overview

Console KVM Switch Rear View

	3	4	6
	RESET
1	2		5

1Power Outlet – The power cord included with the console connects to the unit here.

2Reset Button – Pressing this button for 10 seconds restores the system to its factory default settings.

3Serial Ports 1 and 2 – The KVM features two RJ45 serial ports for connecting serial manageable devices, such as PDUs, firewalls, and routers (see the Serial Pinout section in this manual for the pinout information).

4LAN Ports 1 and 2 – The KVM features two RJ45 LAN ports for connecting to 10/100 Mbps networks. If LAN 1 goes down, LAN 2 takes over. When LAN 1 becomes operational again, the KVM will need to be rebooted to make it the default LAN port again. Note: Only one LAN port can be turned on at a time; they cannot both be turned on. If you don’t wish to use network redundancy, connect a single network cable to the LAN 2 Port.

5USB Port – This port currently serves no functional purpose. It is included for future functionality upgrades.

6Server Ports – When connecting a computer/server, Cat5e/6 cabling connects from an available server port to a B078-101-PS2,

B078-101-USB, or B078-101-USB-1 SIU, which in turn connects to the computer/server.

Rackmount KVM Switch Front View

The NetCommander IP front panel is illustrated in the figure below. Note: The figure below shows a B072-016-IP, but the front panel will be functionally the same for all models.

11MODEL:6B072 - 016 - IP

1

1Power LED – This Blue LED illuminates to indicate that the unit is powered on. No light indicates that the unit is powered off. When a LAN redundancy event occurs, and LAN 2 takes over for LAN 1, this LED will blink slowly. To stop the LED from blinking after a redundancy event, the KVM must be powered off and back on.

7