Tripp Lite OmniPro500 owner manual Storage & Service, Specifications

Storage & Service

Storage

First turn your UPS OFF and disconnect all equipment. Then disconnect its power cord from the wall outlet. If you plan to store your UPS for an extended period of time, fully recharge the UPS batteries once every three months by plugging the UPS into a live AC outlet, and letting the UPS charge for 4-6 hours. If you store your UPS without charging for an extended period of time, its batteries will suffer a permanent loss of power capacity.

Service

If returning your UPS to Tripp Lite, please carefully pack the UPS using the ORIGINAL PACKING MATERIAL that came with the unit. Enclose a letter describing the symptoms of the problem. If the UPS is within the 2 year warranty period, enclose a copy of your sales receipt.

Specifications

	OmniPro 500
Output Capacity (VA/Watts):	500/300
Battery Runtime (Half Load/Full Load) Minutes:	17/5
Typical Runtime (Desktop PC/15 in. monitor) Minutes:	30
Battery Recharge Time (Hours):	2-4
Approvals:	UL, cUL, NOM
Modem/Fax Protection (starts at 260V):	1 line

Input Voltage/Frequency (120V/60 Hz); On-Line Input Voltage Range (98 - 140 volts); Voltage-Regulated Output Voltage Range

(120V ± 5%); On Battery Output Voltage Range (120V ± 5%); Output Waveform Line Mode (filtered sinewave); Output Waveform Battery Mode (PWM sine wave); AC Surge Suppression (exceeds IEEE 587 Cat. A & B standards); AC Noise Attenuation (>40 dB);

AC Protection Modes (H to N, H to G, N to G).

6