2.Installation and Setup (continued)
2.3Configuration
1.Press Enter to open the main menu of the RELAYIOCARD. Press 1 to configure the alarm event for R1~R6.
_8365HOD\&DUG_ )LUPZDUH9HUVLRQ 5HOD\&DUG9 >@&XVWRPL]H2XWSXW5HOD\ >@&RQILJXUH,QSXW6LJQDO >@&XVWRPL]H1RUPDO2SHQRU1RUPDO&ORVH >@4XLW
3OHDVH(QWHU<RXU&KRLFH !
2.Note: Contacts R1~R6 can be configured for different power events.
_&XVWRPL]H2XWSXW5HOD\_
5HOD\6HOHFWHG(YHQW
>@5HOD\ 6XPPDU\$ODUP >@5HOD\ 3RZHU)DLO >@5HOD\ %DWWHU\/RZ >@5HOD\ 2Q%\SDVV >@5HOD\ 2YHUORDG >@5HOD\ 2YHU7HPSHUDWXUH >@%DFN7R3UHYLRXV0HQX
3OHDVH(QWHU<RXU&KRLFH !
4.Press 3 to configure the normal open or normal close for each relay.
_&XVWRPL]H2XWSXW5HOD\_
5HOD\6HOHFWHG(YHQW
>@5HOD\ 1RUPDO&ORVH >@5HOD\ 1RUPDO2SHQ >@5HOD\ 1RUPDO&ORVH >@5HOD\ 1RUPDO2SHQ >@5HOD\ 1RUPDO&ORVH >@5HOD\ 1RUPDO2SHQ >@%DFN7R3UHYLRXV0HQX
3OHDVH(QWHU<RXU&KRLFH !
Once the configuration is complete, SW2 must be switched ON to apply the new settings. To automatically reset to default settings, switch SW2 to the OFF position.
5.Press 0 to quit the configuration session. When the system prompts you to save your settings, press Y to save or N to ignore.
Application Example
Using the default settings, set SW1 and SW2 to OFF. Apply 12V DC to Common contact and connect the lamps to R1~R6 terminals. Install a push button from the Common contact to the input terminal. Press the button for at least 3 seconds to shut down the UPS remotely.
3.Press 2 to configure the input signal.
_&RQILJXUH,QSXW6LJQDO_ >@$FWDV6KXWGRZQRU7HVW 6KXWGRZQ >@,QSXW6LJQDO&RQILUP 6HFRQGV >@'HOD\%HIRUH6KXWGRZQ 6HFRQGV >@%DFN7R3UHYLRXV0HQX
3OHDVH(QWHU<RXU&KRLFH !
Common +12V
GND-R
R1
R2
R3
R4
R5
R6
Input
Summary Alarm
Power Fail
Battery Low
On Bypass
Overload
Over Temperature
Shutdown UPS
In this menu, the input signal can be redefined as a shutdown UPS signal or battery test signal. The UPS shutdown delay time can be adjusted to a maximum of 9999 seconds.
3
200805102 | 7/15/2008 9:19:00 AM |
