13
Basic Operation continued
Control Menu OptionsEnable/Disable Alarm
Tap the buttonrepeatedlytoadvance totheLCDdisplayfeaturing the icon. Press the
buttontoselectON orOFFalarmmode settings.Thelastoption displayedbeforenavigating away
from this menu option will be the selected setting.
Note: Disabling the alarm via this control menu option will silence the alarm under all conditions, including low
battery conditions.
LCD Brightness
Tap the buttonrepeatedlytoadvancetotheLCDBrightnessdisplaymarked“LCD.”Pressthe
buttonto select Medium Backlight (default), High Backlight or Dim Backlight. The last option
displayed before navigating away from this menu option will be the selected setting.
Note: The default brightness is set at medium. Any time a button is pressed, the LCD will engage the high brightness
setting. After 2 minutes of inactivity, the backlight will revert to the selected setting until a button is pressed.
Self-test
Tap the buttonrepeatedlytoadvanceto theTESTBATTdisplay.Pressthe button to initiate
thetest.The test will last approximately 10 seconds as the UPS switches to battery to test the
capacitywithaload.Uponcompletionofthetest,thedisplaywillindicatePASorBAD(passorbad)
for20seconds,andthen returntothehome screen.Connectedequipmentcan remainonduring
thetest.DonotunplugyourUPStotestit;this willremovesafeelectricalgrounding.
Note: If the self-test result is BAD, it may be due to the batteries not being charged for 24 hours. Fully charge the
batteries and repeat the self-test. Please refer to the note under Step 3 on Page 6.
Scroll Control
Thissetting is normally set to “OFF.”Setting it to “ON” allows the user to select the option to
automaticallyscrolleachoperatingconditionoftheUPS(suchasInputVoltage,Output Voltageand
Runtime) automatically.
Tap the button repeatedly to advance to the Scroll display as shown above.
Press the button to advance to the next available option. The last option displayed, before
navigating away from this menu option, will be the selected setting.
Note:
1. Each condition is displayed in 2-second intervals.
2. If a button is pressed while Scroll Mode is enabled, the scroll function will pause for 10 seconds to allow the
user to manually make menu selections.
201205048 93-3149.indb 13 6/19/2012 11:33:40 AM