1 – Introduction
The SRSWITCH is designed to monitor rackmount enclosure door access and notify users when a door has been opened. The SRSWITCH must be used together with the following Tripp Lite accessories: SNMPWEBCARD and ENVIROSENSE (both available separately).
A1 |
| A1 |
Switch (1) |
| |
|
| |
A2 | Magnet (1) |
|
|
| |
A3 | #22 AWG cable - 6 ft. (1.8 m) (1) |
|
|
| |
A4 | Cable ties (6) | A2 |
| ||
|
| |
A5 | Adhesive cable tie holders (3) | A3 |
|
|
A4
A5
Wire Cutters | Wire Strippers | Screwdriver |
2 – Important Safety Instructions
SAVE THESE INSTRUCTIONS
This manual contains instructions and warnings that must be followed during the installation and operation of the products described in this manual. Read all instructions and warnings thoroughly before attempting installation. Failure to comply may invalidate the warranty and cause property damage and/or personal injury.
•Install in a controlled indoor environment, away from moisture, temperature extremes, flammable liquids and gasses, conductive contaminants, dust and direct sunlight.
•Provide suitable grounding in accordance with all applicable electrical wiring regulations.
•Use of this equipment in life support applications where failure of this equipment can reasonably be expected to cause the failure of the life support equipment or to significantly affect its safety or effectiveness is not recommended. Do not use this equipment in the presence of a flammable anesthetic mixture with air, oxygen or nitrous oxide.
2
