Mounting (Tower)

Mount all modules in an upright, tower position using included base stands. The user must determine the fitness of hardware and procedures before mounting.

1The UPS system is shipped with two sets of plastic feet A and extensions B that can be used to tower mount the UPS’s power module, a battery module and either an isolation transformer module or a second battery module.

Adjust the feet to a width of 10.25 inches (26 cm) for a UPS power module and battery module, or to a width of 15.375 inches (39 cm) for three units. Align the feet in your installation area, approximately 10 inches (26 cm) apart. Have one or more assistants help you place the units on their sides in the feet. The control panel of the UPS should be the UPS’s upper corner and face outward. If you are installing a transformer module, place it between the UPS power module and its battery module.

2Rotate the power module’s Control Panel to view it easier while the UPS is tower mounted. Insert a small screwdriver, or other tool, in the slots on either side of the Control Panel. Pop the panel out; rotate it; and pop the panel back into place.

B

A

1

2

4

Page 4
Image 4
Tripp Lite SU6000RT3UXR, SU10KRT3U owner manual Mounting Tower