Service

7

 

 

 

Belt Replacement
Auger Belt

NOTE: It is not necessary to remove both belts in order to change either one. If changing just one belt, be certain to check the condition of the other belt.

1.Allow the engine to run until it is out of fuel. Do not attempt to pour fuel from the engine. Remove the key to avoid unintended starting.

2.Remove the plastic belt cover at the front of the engine by removing the two self-tapping screws. See Fig. 7-1.

Figure 7-1

3.Tip the snow thrower up and forward so that it rests on its auger housing.

4.Remove the frame cover from the underside of the snow thrower by removing the self-tapping screws which secure it. See Fig. 7-2.

NOTE: Tracks removed for clarity

Figure 7-2

5.Roll the auger belt off the engine pulley. See Fig. 7-3.

Figure 7-3

19