Assembly & Set-Up

3

 

 

 

Contents of Crate

 

•

One Snow Thrower

•

Two Replacement Auger Shear Pins

•

One Chute Assembly

•

One Snow Thrower Operator’s

•

One Product Registration Card

•

One Chute Control Rod

 

Manual

 

 

 

 

•One Engine Manual

Assembly
Handle

1.Place the shift lever in the Forward-6 position.

2.Remove the lower plastic wing nut and carriage bolt from each side of the upper handle; raise the upper handle assembly until it snaps over the lower handle. See Fig. 3-1.

NOTE: Make certain the cables are seated properly in the roller guides. See Figure 3-2.

Figure 3-2

Chute Control Head

Chute Support

Bracket

Figure 3-1

3. Looking beneath the handle panel, check that all of the cables (steering, auger, shift, and drive) are properly routed Chute and not pinched or kinked.

4.

Secure the handle by tightening the plastic knob located

 

 

on both the left and right sides of the handle. Remove

 

 

and discard any rubber bands, if present. They are for

 

 

packaging purposes only.

Chute Base

Chute Assembly

 

1.

Remove cotter pin, wing nut and hex screw from chute

Figure 3-3

 

control head. Remove clevis pin and bow-tie cotter pin

 

 

from chute support bracket. See Fig. 3-3.

 

7