Auger Control |
|
|
|
|
|
|
|
|
|
|
|
| Steering Trigger Controls | ||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
The auger control is located on the left handle. Squeeze the control grip against the handle to engage the augers and start snow throwing action. Release to stop.
Drive Control / Auger Clutch LockThe drive control is located on the right handle. Squeeze the control grip against the handle to engage the track drive. Release to stop.
The drive control also locks the auger control so that you can operate the chute directional control without interrupting the snow throwing process. If the auger control is engaged simultaneously with the drive control, the operator can release the auger control (on the left handle) and the augers will remain engaged. Release both controls to stop the augers and wheel drive.
NOTE: Always release the drive control before changing speeds. Failure to do so will result in increased wear on your machine’s drive system.
Heated GripsCAUTION: It is recommended that you wear gloves when using the heated grip. If the heated grip becomes too hot, turn it off.
To activate the heated grips, move the switch found on the rear of the dash panel into the ON position. To turn off the heated grips, move the switch found on the rear of the dash panel to the OFF position.
The left and right wheel steering trigger controls are located on the underside of the handles.
•Squeeze the right control to turn right.
•Squeeze the left control to turn left.
CAUTION: Operate the snow thrower in open areas until you are familiar with these controls.
Electric Chute Directional ControlELECTRIC CHUTEDIRECTIONAL CONTROL
| CHUTE TILT DOWN |
CHUTE | CHUTE |
ROTATE | ROTATE |
LEFT | RIGHT |
The electric chute directional control is located on the right side of the dash panel.
•To change the direction in which snow is thrown, move the
•To change the angle/distance which snow is thrown, pivot the
Section 4 — Controls and Features |
| 13 |
| ||
|
|
|