Chute Assembly

1.Remove cotter pin, wing nut and hex screw from chute control head. Remove clevis pin and bow-tie cotter pin from chute support bracket. See Figure 3-3.

3.Place chute onto chute base and ensure chute control rod is positioned under the handle panel. Secure chute control head to chute support bracket with clevis pin and bow-tie cotter pin removed in step 1. See Figure 3-5.

 

Figure 3-3

 

Figure 3-5

 

4.

Finish securing chute control head by installing hex bolt

2.

Insert the round end of the chute control rod into the chute

control head. Push rod as far into chute control head as

and wing nut. See Figure 3-6.

 

possible, keeping the holes in the rod pointing upward. See

 

Figure 3-4.

 

Figure 3-6

Figure 3-4

8Section 3— Assembly & Set-Up