Troy-Bilt 4510 warranty Controls and Features, Shift Lever, Choke Control, Ignition Key

Controls and Features

4

Chute Assembly

Augers

Drive Control

	Shift Lever
Headlight	Two-Way Chute Control™
	Auger Control

Wheel Steering

Control

Chute Directional
Control
	Fuel Cap
Choke
Primer	Oil Fill
Ignition
Key

Clean-Out Tool	Recoil Starter	starter
	Handle
	Oil Drain	Button
Skid Shoe		Electric starter Outlet

Figure 4-1

Snow thrower controls and features are described below and illustrated in Fig. 4-1.

NOTE: For detailed information on all engine controls, refer to the separate Briggs & Stratton Engine Operator’s Manual.

Shift Lever

The shift lever is located in the right side of the handle panel and is used to determine ground speed and direction of travel.

Forward

There are six forward (F) speeds. Position one (1) is the slowest and position six (6) is the fastest.

Reverse

There are two reverse (R) speeds. One (1) is the slower and two (2) is the faster.

Choke Control

The choke control is found on the top of the engine and is activated by rotating the knob clockwise. Activating the choke control closes the choke plate on the carburetor and aids in starting the engine.

Ignition Key

The ignition key is a safety devise. It must be fully inserted in order for the engine to start. Remove the ignition key when the snow thrower is not in use.

Important: Do not turn the ignition key in an attempt to start the engine. Doing so may cause it to break.

11