Troy-Bilt 644H Danger, Introduction, Initial Operation, Startingand Stoppingthe Engine, 1

Models: 644H

1 36
Download 36 pages 18.6 Kb
Page 13
Image 13
Operation

n

Operation

WARNING

Before operating your machine, carefully read and understand all safety (Section 1), controls (Section 3) and operating instructions (Section

4)in this Manual, in the separate Engine Owner's Manual, and on the decals on the machine.

Failure to follow these instruc- tions can result in serious personal injury.

Recoil Starter

,Reverse ClutchControl

ForwardClutchBail

ulator Lever

Wheel Drive Pin (on eachwheel)

INTRODUCTION

Readthis Section of the manual thor- oughly before you start the engine. Then, take the time to familiarize yourself with the basic operation of the tiller before using it in the garden. Find an open, level areaand practice using the tiller controls without the tines engagingthe soil (put tines in "travel" setting). Only after you'vebecomecompletely familiar with the tiller should you begin using it in the garden.

INITIAL OPERATION

Perform the following maintenanceduring

the first hours of new operation (see "Maintenance"section in this manual and

in the EngineOwner'sManual).

1.Changeengineoil after first 2 hours of new engine operation.

2.Checkfor loose or missing hardware on unit. Tighten or replace as needed.

3.Checktension on forward drive belt after first 2 hours of operation.

4.Checktransmission gear oil levelafter first 2 hours of operation.

Figure4-1
STARTINGAND STOPPINGTHE ENGINE

Pre-Start Checklist

Makethe following checksand perform the following services before starting the engine.

1.Readthe "Safety" and "Controls" sections in this manual. Readthe

separateEngineOwner'sManual provided by the engine manufacturer.

2.Checkthat the wheelsare in the

WHEELDRIVEposition (wheel pins must bethrough the wheel hubs and the wheel shaft holes).

3.Check unit for loose or missing hardware. Serviceas required.

4.Checkengine oil level. See Engine Owner'sManual.

5.Checkthat all safety guards and covers are in place.

6.Checkair cleaner and enginecooling system. SeeEngineOwner'sManual.

7.Attach spark plug wire to spark plug.

8.Fill the fuel tank with gasoline according to the directions in the separateEngineOwner'sManual. Follow all instructions and safety rules carefully.

DANGER

GASOLINE IS HIGHLY

FLAMMABLE AND ITS VAPORSARE EXPLOSIVE.

Follow gasolinesafety rules in this manual (see Section 1) and in the separate Engine Owner'sManual.

Failure to follow gasoline safety instructionscan result in serious personal injury and property damage.

13

Page 13
Image 13
Troy-Bilt 644H manual Danger, Introduction, Initial Operation, Startingand Stoppingthe Engine, 1