moving partsto come to a complete stop, disconnectspark plug wire and move wire awayfrom WARNING: Beforeinspecting, cleaning or servicing the machine,shut off engine, wait for all
spark plug. Failureto follow these instructions can result in serious personal injury or property damage.
TROUBLESHOOTING
PROBLEM |
| POSSIBLECAUSE |
Enginedoes not start | 1. | Spark plug wire disconnected |
| 2. | Engine Throttle Control Lever incorrectly set. |
| 3. | Fuel tank empty. |
| 4. | Choke control (if so equipped) in incorrect position. |
| 5. | Stale gasoline. |
| 6. | Dirty air filter. |
| 7. | Defective or incorrectly gapped spark plug. |
| 8. | Carburetor out of adjustment. |
| 9. | Misadjusted throttle control. |
| 10. | Dirt or water in fuel tank. |
Enginerunspoorly. | 1. | Defective or incorrectly gapped spark plug. |
| 2. | Dirty air filter(s). |
| 3. | Carburetor out of adjustment. |
| 4. | Stale gasoline. |
| 5. | Dirt or water in fuel tank. |
| 6. | Engine cooling system clogged. |
Engineoverheats. | 1. | Engine cooling system clogged. |
| 2. | Carburetor out of adjustment. |
| 3. | Oil level is low. |
CORRECTION
Reconnectwire.
2.Put lever in STARTposition.
3.Add fuel.
4.See Engine Owner'sManual.
5.Drain fuel and add fresh fuel.
6.Clean or replace filter.
7.Inspect spark plug.
8.See Engine Service Dealer.
9.See Engine Service Dealer
10.See Engine Service Dealer.
Inspect spark plug (see Engine Owner'sManual).
2.Clean or replace (see Engine Owner'sManual).
3.See Engine Service Dealer.
4.Replacewith fresh gasoline.
5.See Engine Service Dealer.
6.Cleanair cooling system (see Engine Owner'sManual). Cleanair cooling area (see Engine Owner'sManual).
2.See Engine Service Dealer.
3.Check oil level (see Engine Owner'sManual).
Enginedoesnotshutoff WheelsandTineswill notturn
Tinesturn,butwheelsdon't,
1.Misadjusted throttle control or ignition switch.
1.Improper useof controls.
2.Forward Drive: Misadjusted forward clutch rod.
3.Reverse Drive. Broken or misadjusted belt.
4.Worn Broken or misadjusted Drive Belt(s).
5.Internal transmission wear or damage.
6.Bolt and key loose in transmission pulley.
1.Wheel Drive Pins not in WHEEL DRIVE.
2.Bolt loose in transmission pulley.
3.Internal transmission wear or damage.
1.See Engine Owner'sManual or Engine Service Dealer.
1.Review Sections 3 and 4.
2.See "Handlebar Height Adjustment," Section 3.
3.Replacebelt or adjust belt tension. Section 5.
4.See "Checking Drive Belt Tension," Section 5.
5.Contact local dealer or the factory.
6.Tighten bolt. Check that key is in place.
1.See "Wheel Drive Pins" in Section 3.
2.Tighten bolt.
3.Contact local Dealer or the Factory.
WheelsTurn,butTinesDon't,
Poortillingperformance.
1.Tine holder mounting hardware missing.
2.Internal transmission wear or damage.
1.Worn tines.
2.Improper Depth Regulator setting.
3.Incorrect throttle setting or belt range speed.
4.Belt(s) slipping.
1.Replacehardware.
2.Contact local Dealer or the Factory.
1.See "Tines" (Section 5).
2.See "Tilling Tips & Techniques," Section 4.
3.See Section 4.
4.See "Checking Forward Drive Belt Tension," Section 5.
23
