Problem |
| Cause |
| Remedy | |
|
|
|
|
| |
|
|
|
|
| |
Wood will not split or wood | 1. | Small gear section damaged. | 1. | See authorized service dealer. | |
splits too slowly | 2. | Pump check valve leaking. | 2. | See authorized service dealer. | |
| |||||
| 3. | Excessive pump inlet vacuum. | 3. | Make certain pump inlet hoses are clear and | |
|
|
|
| unblocked. | |
| 4. | Incorrect oil level. | 4. | Check oil level. | |
| 5. | Contaminated oil. | 5. | Drain oil, clean reservoir and refill. | |
| 6. | Control valve leaking internally. | 6. | See authorized service dealer. | |
| 7. | Overloaded cylinder. | 7. | Do not attempt to split wood against the grain. | |
| 8. | Internally damaged cylinder. | 8. | See authorized service dealer. | |
|
|
|
|
| |
Leaking pump shaft seal | 1. | Broken drive shaft. | 1. | See authorized service dealer. | |
| 2. | Engine/pump misalignment. | 2. | Correct alignment as necessary. | |
| 3. | Gear sections damaged. | 3. | See authorized service dealer. | |
| 4. | Damaged shaft seal. | 4. | See authorized service dealer. | |
| 5. | Plugged oil breather. | 5. | Make certain reservoir is properly vented. | |
|
|
|
|
| |
Wedge continues to move | 1. | Damaged control valve | 1. | See authorized service dealer. | |
forward when control |
|
|
|
| |
handle is released |
|
|
|
| |
|
|
|
|
| |
Control handle does not | 1. | Hydraulic fluid too cold. | 1. | Warm up engine. | |
return to neutral when | 2. | Hydraulic fluid too thick. | 2. | Replace hydraulic fluid. | |
released from forward | |||||
|
|
|
| ||
position | 3. | Hydraulic fluid contaminated. | 3. | Replace hydraulic fluid. | |
| 4. | Damaged control valve. | 4. | See authorized service dealer. | |
|
|
|
|
|
Section 8 — Troubleshooting |
| 19 |
| ||
|
|
|