•If not already attached, slip the cables that run from the handle panel to the chute assembly into the cable guide located on top of the engine. See Figure 4.
•If not already attached, unwrap the headlight wire which is attached to the headlight, beneath the handle panel. Wind the headlight wire around the lower right handle until excess slack is removed. See Figure 4.
Cables | Cable |
| Guide |
Discharge |
|
Chute |
|
Figure 4
•Plug the wire from the headlight into the alternator lead coming from the right side of the engine underneath the fuel tank.
Alternator Lead
Alternator
Lead
Lamp Wire
NOTE: Tracks are omitted from illustration for clarity.
Figure 5
Clean-Out Tool
•This tool, along with the electric cord, is fastened with a cable tie to the rear of the auger housing for shipping purposes. Cut the cable tie and remove the electric cord before operating the snow thrower.
SECTION 3: KNOW YOUR SNOWTHROWER
Drive Control / | Shift Lever |
| |
Auger Control Lock | Chute Tilt |
| |
Heated Handles | Control |
| |
Heated Grip† |
| ||
Switch† |
| ||
Headlight† | Auger Drive Control |
| |
|
| ||
Chute | Track Steering | Electric | |
Assembly | Starter | ||
Control | |||
| Button | ||
|
| ||
Primer | Switch | ||
Tool |
| Box | |
| Choke | Recoil | |
|
| Starter | |
|
| Handle | |
Chute Directional |
| ||
Control | Safety | Closed | |
| Ignition Key |
| |
Skid Shoe | Throttle | Open | |
Control | |||
Auger | Fuel | ||
† Optional | |||
| |||
|
| *If Equipped | |
Figure 6
WARNING: Read, understand, and follow all instructions and warnings on the machine and in this manual before operating.
Drive Control / Auger Control Lock
The drive control is located on the right handle. Squeeze the drive control to engage the wheel drive. Release to stop. See Figure 6.
6
