|
| hole in the shift lever. See Figure 12. | |
| Frame Cover | • Insert ferrule from the left side of the snow thrower | |
| into the upper hole. |
| |
|
|
| |
|
| • Reinstall the hairpin clip and the washer. | |
|
|
| Shift Lever |
|
| Hairpin Clip |
|
|
| Flat | Ferrule |
|
|
| |
Auger |
| Washer | Upper Shift Rod |
Housing |
|
| |
|
|
| |
|
| Shift Rod | Hairpin Clip |
|
| Connector |
|
| Figure 10 |
| Lower Shift Rod |
|
|
| |
•With the traction control lever engaged, the friction wheel must contact the drive plate. See Figure 11.
If adjustment is necessary:
•Loosen the jam nut on the traction cable and thread the cable in or out as necessary.
•Retighten the jam nut to secure the cable when correct adjustment is reached.
•Reassemble the frame cover.
Gear Shaft | Drive |
Cable | |
Friction Wheel | Pivot Rod |
| |
Rubber |
|
| Drive |
| Plate |
Figure 11
NOTE: If you placed plastic film under the gas cap, be certain to remove it before operating the snow thrower.
Shift Arm
Figure 12
IMPORTANT: Make certain to check for correct adjustment of the shift rod as instructed under “Drive Control and Shift Lever” on page 11, before operating the snow thrower.
Skid Shoe
The space between the shave plate and the ground can be adjusted by raising or lowering the skid shoes.
For close snow removal, as when using on a smooth concrete or asphalt driveway, place the skid shoes in the low position. Use the middle or high position when the area to be cleared is uneven. When operating on gravel, always put skid shoes in the high position. See Figure 13.
Adjust skid shoes as follows:
•Loosen, but do not remove, the three hex nuts which fasten the skid shoe to the auger housing.
•Raise or lower the skid shoe to desired position.
•Retighten the hex nuts loosened earlier.
•Repeat on the other side of the snow thrower.
Shift Rod Adjustment
•Remove the hairpin clip and flat washer from the shift handle under the handle panel. See Figure 12.
•Place shift lever in sixth (6) position or fastest forward speed.
•Push shift arm assembly down as far as it will go.
•Rotate the ferrule up or down on the shift rod as necessary until the ferrule lines up with the upper
NOTE: Make certain the bottom surface of skid shoe is flat against the ground to avoid uneven wear.
12
