Installation

Installation instructions

WARNING!
This appliance must be earthed
• If your appliance has been damaged in
transit, contact your supplier immediately.
Do not attempt to install it.
• Your appliance left the factory fully packaged
to protect it from damage. If it is delivered
without packaging and damage has occur-
red, the manufacturer cannot accept
responsibility. Contact your supplier for ad-
vice.
• Once the packaging has been removed the
appliance should only be moved by hand.
Do not use a sack barrow or any other aid to
lift the appliance as damage may occur. Do
not carry the appliances at the doorhandle.
• To move the appliance, open the oven door
and lift the appliance by holding inside the
top of the compartment.
• This is a type X appliance, which means it is
freestanding and can be fitted with cabinets
on one or both sides.
• Sidewalls, which are above hob level, should
be protected by heat resistant non-combus-
tible material and must not be nearer than
40mm to the hob side.
• A nominal air gap of 2mm at either side of
the appliance is required to enable the ap-
pliance to be moved into position.
• Always ensure an air gap is maintained at
hotplate level. Tiles or other forms of deep
wall covering should not obscure this gap.
• Overhanging surfaces or a cooker hood
should be a minimum of 685mm above the
hob.
• It is important to ensure that the appliance is
level after installation. Levelling feet are fit-
ted to the appliance to accommodate un-
even floors.

Adjustment of levelling feet

The cooker stands on 4 levelling feet. It is re-
quired to confirm the appliance is correctly
levelled before operating it. This adjustment
can be made by turning the levelling feet clock-
wise or anti-clockwise, if required. It is possible
to raise the product up to maximum of 35 mm
via the levelling feet. If it becomes necessary
to move the appliance after the levelling feet
have been adjusted, it is advisable to lift and
not drag. The levelling feet can be adjusted by
hand or by using a metal coin of the correct size.

Connecting to the electricity

supply

WARNING!
This appliance must be earthed. Do not earth
this appliance to gas supply piping. Connect to
230 - 240V AC supply only.
• Connection to the electricity supply must be
carried out by a qualified electrician/compe-
tent person.
27