Figure 13
SIDE DISCHARGE GRASS CLIPPINGS
This mower can also side discharge grass clippings. Follow steps 1 and 2 to ready this mower for side discharge operation.
1.Remove mulching baffle or grass bag adapter. See Figure 10.
2.Attach discharge chute with wing nuts. See Figure 14.
Side
Discharge
Chute
Wing Nut
Figure 14
ADJUSTMENT
CAUTION: DO NOT AT ANY TIME MAKE ADJUSTMENTS TO LAWNMOWER WITH- OUT FIRST STOPPING THE ENGINE AND DISCONNECTING THE SPARK PLUG WIRE
CAUTION: Before changing mowing height, stop mower and disconnect spark plug cable.
MODELS WITH SINGLE LEVER HEIGHT ADJUSTERS:
Refer to “Controls Section” and Figure 5.
BOTTOM
VIEW
| en |
os | |
Lo |
|
| n |
hte | |
Tig |
|
Figure 15
DRIVE CLUTCH CONTROL ADJUSTMENT
Use the adjustment wheel located on the un- derside of the clutch control housing to tighten the drive belt if mower does not
In addition, the adjustment wheel may also be used to determine the position in which the drive clutch control is engaged. If it is more comfortable to have the drive engaged with the lever further away from the handle, tighten the drive belt.
Make certain to retest the unit for neutral as instructed in the operation Section. Move the adjustment wheel in the opposite direction to loosen the drive belt if necessary.
SIX SPEED SHIFT CABLE ADJUSTMENT
Periodic adjustment of the six speed shift ca- ble may be required due to normal stretch and wear on the cable. Adjustment is needed if all six speeds cannot be obtained.
The adjustable cable bracket is located on the left side of the mower, beside the engine. To adjust, loosen the hex nut which secures the adjustable cable bracket. See Figure 16. Pull backward on the bracket (toward the rear of the mower). Retighten the hex nut. Test the speeds on the mower (engine must be running).
CARBURETOR ADJUSTMENT
Refer to the separate engine manual packed with your mower for carburetor adjustment information.
12
