2.Insert the cable into the slot on the control panel and fit the threaded assembly into the hole in the slot. Be sure that the flat side of the threaded assembly is aligned with the flat side of the hole. Slide the hex nut up the cable and tighten it securely.

3.Test the function of the reverse clutch control cable by pulling the knob out and releasing it. The knob should return to its neutral position against the tapered bushing. If it does not, contact your local dealer or the factory for technical assistance.

Forward Clutch Cable

1.Remove any fasteners (rubber bands, tape, etc.) that may secure the Forward Clutch Control levers to the handlebar. See Fig. 3-5.

Forward Clutch

Control Levers

Figure 3-5

2.The forward clutch control cable (with attached spring) is hanging loosely near the right-side wheel. Being careful not to kink or stretch the cable, insert the Z-connector into the hole at the end of the forward clutch control linkage. See Fig. 3-6.

Z-Connector

Forward Clutch

Control Spring

Figure 3-6

3.Attach the cable adjuster to the bracket on the right-side handlebar. See Fig. 3-7. Use two 1⁄2” wrenches to loosen the two jam nuts just enough to slide the cable adjuster onto the bracket. Then hand tighten the jam nuts.

Cable

Adjuster

Jam Nuts

Figure 3-7

warning! Incorrect cable adjustment could cause the wheels and tines to rotate unexpectedly. Follow adjustment procedures carefully. Failure to do so could result in personal injury or property damage.

4.Check for the correct spring/cable tension as instructed in the Maintenance & Adjustments Section.

5.When the tension is correct, tighten the two jam nuts securely.

Section 2— Assembly & Set-Up