2.Using two hex screws and two flange lock nuts, loosely attach the handlebar support using the upper holes. Tighten the two screws securely. See Fig. 3-2.

Hex Screw

Upper Handle

Flange Lock Nut

Handle Support

Figure 3-2

3.Loosely attach the support brackets to the outside of the handlebar assembly using the carriage bolt, bell washer and knob. Refer to Fig. 3-3.

Knob

Carriage Bolt

Bell Washer

Figure 3-3

NOTE: If a support bracket will not move, loosen the attaching hex screws (5⁄16-18 x .75) and flange lock nuts (5⁄16- 18) at the base of the support brackets.

NOTE: The support brackets must be assembled to the outside of the handlebar assembly.

4.There are three height adjustment holes in the handlebar support bracket. Use a setting that will position the handlebars at approximately waist level when the tines are

3-4” into the soil. To adjust the height of the handlebars loosen the knob on the handle, pull out on the carriage screw, adjust to the desired setting, push the carriage screw in until the square portion of the screw locks into place and re-tighten the knob. See Fig. 3-4.

Knob

Carriage Screw

Figure 3-4

4.Tighten all the handlebar mounting hardware securely.

Move Tiller Off Crate

To roll the tiller off the shipping platform, put the wheels in freewheel, as follows:

1.Place a sturdy block under the transmission to raise one wheel about 1” off the ground.

2.Remove the wheel drive pin from the wheel hub and wheel shaft. See Fig. 3-5.

Wheel Drive Pin

Wheel Shaft

Figure 3-5

8Section 3— Assembly & Set-Up