Troy-Bilt TB5018CC, TB5020CC manual STARTING/STOPPING Instructions, Chain properly installed

STARTING/STOPPING INSTRUCTIONS

WARNING: Operate this unit only in a well- ventilated

outdoor area. Carbon monoxide exhaust fumes can be lethal in a confined area.

WARNING: Never operate the saw without the bar and

chain properly installed.

STARTING INSTRUCTIONS

1.Slide the STOP switch down (Fig. 2).

2.Rotate the choke lever up to the horizontal position (Fig. 3).

3.Pump primer bulb 10 times (Fig. 4).

4.Pull starter rope 4-6 times, engine should start (Fig. 5).

5.If engine failed to start, rotate choke lever down to vertical position then repeat step 4 (Fig. 5).

6.When engine starts, warm up 10 sec.

Then depress safety/throttle trigger.The automatic choke will disengage when trigger is pulled (Fig.6).

7.Release throttle trigger for idle.

TO STOP: Slide stop switch up.

NOTE: This unit will not run with the choke lever in

horizontal Position 1.

NOTE: The unit uses Spring Assist Starting™, which significantly reduces the effort required to start the engine. You must pull the starter rope out far enough to hear the engine attempt to start. There is no need to pull the rope briskly-- there is no harsh resistance when pulling. Be aware that this starting method is vastly different from (and much easier than) what you may be used to.

C A

B

Fig. 1

D

Fig. 2

Horizontal position

Vertical position

Fig. 3

F

Fig. 4

Fig. 5

Automatic

A

B

Fig. 6

10