MAINTENANCE AND REPAIR INSTRUCTIONS
AIR FILTER
CAUTION: Never operate saw without the air filter.
Dust and dirt wil be drawn into engine and damage it. Keep the air filter clean.
1.Remove the top cover (A) by loosening the cover retaining screws. Cover will lift off (Fig. 31).
2.Clean air filter. Wash filter in clean, warm, soapy water. Rinse in clear, cool water. Air dry completely.
NOTE: It is advisable to have a supply of spare filters.
3.Install air filter. Install engine / air filter cover. Make sure cover fits properly. Tighten the cover retaining screws securely.
WARNING: To avoid serious personal injury,
always turn your unit off and allow it to cool before you clean or service it.
B
FUEL FILTER
CAUTION: Never operate saw without the fuel filter.
The fuel filter should be replaced after each 20 hours of use. Drain fuel tank before changing.
1.Remove air box cover and air filter as shown in Fig. 31.
2.Disconnect fuel hose (A) from carburetor fitting (Fig. 32).
3.Pull fuel filter (C) out of tank with a bent wire (D) or long needle nosed pliers. Disconnect filter and discard (Fig. 32).
NOTE: Do not pull hose completely out of tank.
4.Install a new fuel filter on hose and pull hose/filter assembly back into tank so filter is positioned in front right corner.
5.Reconnect fuel hose (A) to carburetor fitting (B) (Fig. 32). Replace air filter and air box cover.
6.Fill tank with fresh fuel / oil mixture. See Oil and Fuel Information. Install fuel cap.
B
A 
Fig. 31
C
D
A
Fig. 32
17
