MAINTENANCE AND REPAIR INSTRUCTIONS

REPLACING THE CHARGER

Replace the charger if it is damaged, if the barrel connector or cord become damaged, or if the barrel connector is not contacting the unit properly.

CAUTION: Only use the type of charger specified for

this unit. Any other type may cause damage to the unit, damage to the batteries or possible injury.

Your trimmer requires a 12V charger (791-182534) and charging station (791-180295). The charging instructions refer only to these parts.

1.Unplug the charger from the wall outlet and remove the unit from the charging station.

2.Remove the screw from the clamp holding the barrel connector in place using a standard or T-20 Torx bit screwdriver (Fig. 19).

3.Remove the barrel connector from the slot and replace the charger, if needed.

4.Insert the narrow side of the barrel connector wire into the groove in the slot of the charging station. Ensure that the barrel connector is inserted correctly and secure (Fig. 19).

5.Reinstall the clamp and screw.

6.Plug the charger into the wall outlet. Refer to Charging the Unit for charging instructions.

Barrel Connector

Edge of Barrel

Connector Wire

Clamp

Groove

Charging Station

Charger

Fig. 19

CLEANING

WARNING: To prevent serious personal injury,

remove or disconnect the battery before servicing, cleaning or removing material from the unit.

WARNING: Battery tools do not have to be plugged

into an electrical outlet; therefore, they are always in operating condition. To prevent serious personal injury, take extra precaution and care when cleaning the unit.

Switch off the unit and disconnect it from the power source. Use a small brush to clean off the outside of the unit. Do not use strong detergents. Household cleaners that contain aromatic oils such as pine and lemon, and solvents such as kerosene, can damage plastic housing or handle. Wipe off any moisture with a soft cloth. Also keep the air vents free of obstructions.

STORAGE

•Allow the unit to cool before storing.

•Lock the unit to prevent unauthorized use or damage.

•Store the unit in a dry, well-ventilated area.

•Store the unit out of the reach of children.

ACCESSORIES AND REPLACEMENT PARTS

Cutting Attachment Shield . . . . . . . . . . . . . . . . . 180293

Replacement Line . . . . . . . . . . . . . . . . . . . . . . . 610375

Replacement Line Cartridge . . . . . . . . . . . . . . . . 180292

Inner Reel Spring . . . . . . . . . . . . . . . . . . . . . . . . 180374

Bump Head Cover . . . . . . . . . . . . . . . . . . . . . . . 180376

Charger . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 182534

Charging Station . . . . . . . . . . . . . . . . . . . . . . . . . 180295

12 Volt Battery Pack . . . . . . . . . . . . . . . . . 791-182391B

14