ASSEMBLY INSTRUCTIONS

ADJUSTING THE D-HANDLE

NOTE: The D-handle comes mounted on the backside of the shaft.

1.Locate the wing nut on the D-Handle. Untighten the wing nut enough to loosen the D-Handle (Fig. 1).

NOTE: Do not remove wing nut, washer, or bolt.

2.Rotate the D-Handle to the upright position on the front side of the shaft housing (Fig. 1).

NOTE: The D-handle should slant towards the powerhead of the unit.

Wing Nut

Fig. 1

3.Hold the unit in the operating position. If necessary, reposition the D-handle to the location that provides the best grip (Fig. 2).

MOUNTING THE CHARGING STATION

NOTE: Mount the charging unit and allow the unit to charge for at least 36 hours prior to first use.

This unit may stay on the charging station continuously without overcharging. Place the charging station where the unit is intended to be stored. This should be a cool, dry and well ventilated place, where the unit can be locked-up and out of the reach of children.

The unit should be stored and charged in a location where the temperature is between 50˚F (10˚C) and 100˚F (38˚C).

1.Locate a place for the charging station near a wall outlet and high enough to keep the unit off the floor.

2.Locate the wall stud and mount the charging station to the wall using the three (3) screws provided

(Fig 3). Make sure that the screws enter the wall stud to provide a secure mount.

Charging Station

 

Screws

 

 

Wall

Wall Outlet

Stud

Charger

Cord Wrap

Charging

Indicator Light

Fig. 3

CAUTION: To prevent injury or damage to the unit,

the charging station must be mounted securely to the wall.

3.Plug the charger into the wall outlet and wind any excess wire onto the cord wrap on the charging station (Fig. 3).

Fig. 2

4. Tighten the wing nut until the D-Handle is secure.

7