TROUBLESHOOTING

 

 

MOTOR OPERATES SLOWLY OR WILL NOT OPERATE

C A U S E

A C T I O N

Battery is not charged

Charge the battery

Overload protection switch has popped

Reset overload protection switch

 

 

BATTERY WILL NOT CHARGE

 

C A U S E

A C T I O N

No power to charger or battery

Check charger and charging station

Battery has failed

Replace the battery

 

CUTTING ATTACHMENT WILL NOT ADVANCE LINE

C A U S E

A C T I O N

Cutting attachment bound with grass

Stop the unit and clean cutting attachment

Cutting attachment out of line

Refill with new line

Inner reel bound up

Replace the inner reel

Cutting attachment dirty

Clean inner reel and outer spool

Line welded

Disassemble, remove the welded section

 

and rewind the line

Line twisted when refilled

Disassemble and rewind the line

Not enough line is exposed

Push the Bump Knob and pull out line until

 

4 inches (102 mm.) of line is outside of the

 

cutting attachment

SPECIFICATIONS

BATTERY AND MOTOR

Motor ..................................................................................................................................................

12 Volt DC, 15 Amps

Battery.........................................................................................................................................

Sealed Lead-Acid, 12 Volt

Motor Wire Housing Tube............................................................................................................................

Aluminum Tube

Unit Weight (With battery, cutting attachment shield and D-handle) ......................................................

10.2 lbs. (4.63 kg.)

Cutting Mechanism.............................................................................................................................................

Bump Head

Line Spool Diameter......................................................................................................................................

3 in (76.2 mm)

Trimming Line Diameter .........................................................................................................................

0.080 in (2.03 mm.)

Cutting Path Diameter.................................................................................................................................

10 in. (254 mm)

15