Troy-Bilt Two-Stage Snow Thrower Setting Up Your Snow Thrower, Prior to operating, Test on page

Models: Two-Stage Snow Thrower

1 52
Download 52 pages 11.8 Kb
Page 7
Image 7
Prior to operating

4. Finish securing chute control assembly to chute

 

3

 

 

support bracket with wing nut and hex screw removed

4

 

earlier. See Figure 4.

 

Setting Up

Your Snow

Thrower

5.Check that all cables are properly routed through the cable guide on top of the engine. See Figure 5.

The extension cord is fastened with a cable tie to the rear of the auger housing for shipping purposes. Cut the cable tie and remove it before operating the snow thrower.

CAUTION: Prior to operating your snow thrower, refer to Auger Control Test on page 13. Read and follow all instructions carefully, and perform all adjustments to verify your snow thrower is operating safely and properly.

Figure 4

CAUTION

 

 

Prior to operating

 

your snow thrower,

5

refer to Auger Control

Test on page 13.

 

Read and follow all

 

instructions care-

 

fully and perform all

 

adjustments to verify

 

your unit is operating

 

safely and properly.

Figure 5

Shear Pin Storage (optional)

An area for convenient shear pin storage is located under the plastic dash panel. See Figure 6.

Figure 6

7

Page 7
Image 7
Troy-Bilt Two-Stage Snow Thrower warranty Setting Up Your Snow Thrower, Prior to operating, Test on page, instructions care