3
Setting Up
Your Snow
Thrower
WARNING
Never use your hands to clean snow and ice from the chute assembly or auger housing.
IMPORTANT Under any circum- stance do not exceed manufacturer’s recom- mended psi. Equal tire pressure should be maintained at all times. Excessive pressure when seating beads may cause tire/rim assembly to burst with force sufficient to cause serious injury. Refer to sidewall of tire for recommended pressure.
Drift Cutters (If Equipped)
Drift cutters should be used when operating the snow thrower in heavy drift conditions.
• On models so equipped, drift cutters are assembled to the auger housing inverted. See Figure 7.
• Remove the carriage bolts by unthreading the hex nuts which secure them, and reinstall the drift cutters facing forward before operating the snow thrower. Refer to Figure 8.
• Secure to the auger housing with carriage bolts and hex nuts previously removed. See Figure 9.
If your unit is not equipped with drift cutters, you may contact Customer Support as instructed on page 2 for information regarding price and availability.
Snow Thrower Model | Drift Cutter Kit: |
All models- |
Figure 7
Figure 8
Figure 9
8
