O w n e r ’ s m a n u a l • E 3 0
By holding on to the seat, incline the equipment backwards so that it rests on its transportation wheels. Attach the rear support from below with four hexagonal socket head screws and washers. Attach the front support to the frame with four screws and washers. Restore the equipment to its upward position so that it rests on the support feet.
PEDALS
The pedals are distinguished by the markings R (= right) and L (= left) on their shafts. Fasten the right pedal to the right pedal crank turning clockwise and the left pedal to the left pedal crank turning counterclockwise. Fasten the pedal bands first into the retainerat the device. Thread the band through the pedal loop and push the band opening into the projection in the pedal. Fasten the pedal bands to the pedal outside. Push the band through the locking buckle and the band locks automatically. The length of the band can be adjusted with the locking buckle.
HANDLEBAR
Attach the cable coming from the frame tube to the connector at the bottom of the handlebar.
Ensure that the joint is securely locked by gently pulling the wire. Thread the wire carefully inside the frame tube and push the handlebar support tube into place inside the frame tube so that the fastening screws are on the front of the tube.
NOTE! Use the enclosed Allen key to tighten both fastening screws through the holes in the tube.
Tighten the fastening screws by turning them
CONSOLE
1.Connect the cables from the handlebar to the corresponding connectors of the console. Insert the connected cables into the console, but make sure they are not damaged when the console is attached.
2.Place the console in position at the end of the handlebar support tube and attach the console using mounting screws.
